Panasonic VDR-D105 작동 가이드

다운로드
페이지 108
26
LSQT1040
Se
tu
p
Inserting/removing a disc
∫ Identifying recording/playback sides of disc
Single sided disc:
The recording/playback side is opposite to the labelled side.
Double sided disc:
The “SIDE A” recording/playback side is opposite to the “SIDE A” marked 
side. The “SIDE B” recording/playback side is the “SIDE A” marked side.
≥ Do not use excessive force when opening the cover.
≥ Do not touch the pickup lens or the recording/
playback side of the disc. 
This may impair recording and playback. 
≥ Insert the disc securely to prevent damage.
≥ When you open the cover, the ACCESS/PC lamp 
flashes red. Do not leave the cover open.
≥ If the cover is open, the power will not turn off even 
if the OFF/ON switch is set to OFF.
≥ If the disc is not correctly inserted, the cover will not 
close. Never try to forcibly close the cover. This 
could cause damage. Reinsert the disc properly.
≥ If a single sided disc is inserted into the unit with the 
printed label facing the inside, an error message will 
appear. Remove the disc and reinsert it with its 
recording/playback side facing the inside.
≥ Do not allow the recording/playback side to become 
dirty or scratched.
≥ Do not remove the battery pack or disconnect the 
AC adaptor while removing the disc or until power is 
completely turned off. If you do, the cover will not 
open. If this happens, reattach the battery pack or 
reconnect the AC adaptor, slide the DISC EJECT 
lever once, and then release it. A repair disc 
message may be displayed when the power is 
turned back on. (l 83, About recovery)
≥ Do not insert anything other than the 8 cm (3z) 
DVD-RAM, DVD-RW or DVD-R disc into the disc 
compartment. Doing so could cause malfunctions.
≥ Do not touch the pickup lens or other parts inside 
the disc compartment. Be sure not to touch the area 
around the pickup lens for it becomes extremely 
hot.
DV
D-R
AM / SIDE
A
“SIDE A” mark
The opposite side is 
the “SIDE A” recording/ 
playback side.
After inserting a disc/After recording finishes
While the ACCESS/PC lamp is lit, the disc is rotating and disc information is being recorded. If 
the power supply is interrupted at this time, the disc may become unusable. Do not disconnect 
the AC adaptor or remove the battery. Also, do not strongly shake or cause impact to the unit.
D105(P)eng.book  26 ページ  2006年1月16日 月曜日 午後4時1分