Panasonic th-47lf30 사용자 가이드

While the POS. /SIZE display is active, if either the N button on the remote control is pressed at any time or the ACTION
( ) button is pressed during “NORMALIZE”, then all adjustment values (except “CLOCK PHASE” and “DOT CLOCK”)
are returned to the factory settings.

Helpful Hint ( /

NORMALIZE

Normalization)

H-POS

Adjust the horizontal position.

V-POS

Adjust the vertical position.

H-SIZE

Adjust the horizontal size.

V-SIZE

Adjust the vertical size.

CLOCK
PHASE

(During Component, RGB and PC input signal)
Eliminate the fl ickering and distortion.

DOT
CLOCK

(During Component, RGB and PC input signal)
Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,
adjust so that any such noise is minimized.

OVER
SCAN

Turn image over scan ON/OFF.
Confi gurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, DVI, HDMI)

            ON                               OFF
Notes:
•  “OFF” is effective during only “FULL” aspect mode.
•  When “OFF” is set, “H-SIZE” and “V-SIZE” cannot be adjusted.

1:1 PIXEL
MODE

Adjusts the display size when 1125i or 1125p signal is input.

Notes:
•  “ON” is effective during only “FULL” aspect mode.
•  Select ON when you would like to replay 1920 × 1080 input signal.
•  Applicable input signal;
  1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p
•  Select OFF when fl ickering is shown around the image.
•  H-SIZE and V-SIZE cannot be adjusted when ON is selected.

OFF

Adjusting POS. /SIZE