Panasonic cn-nvd905 사용자 가이드

 Keep the sound volume at an appropriate level.
   Keep the volume level low enough to be aware of 

road and traffi c conditions while driving.

  Do not insert or allow your hand or fi ngers to be 

   To prevent injury, do not get your hand or fi ngers 

caught in moving parts or in the disc slot. Especially 
watch out for infants.

  This unit is designed for use exclusively in 

  Do not operate the unit for a prolonged period with 

   Operating the audio system for a long period of time 

with the engine turned off will drain the battery.

  Do not expose the unit to direct sunlight or 

   These will raise the interior temperature of the unit, 

and may lead to smoke, fi re, or other damage to the 
unit.

  Do not use the product where it will be exposed to 

   Exposure of the unit to water, moisture, or dust may 

lead to smoke, fi re, or other damage to the unit. 
Make especially sure that the unit does not get wet 
in car washes or on rainy days.

  Do not place items on the opened monitor.
   There is risk of breakage to the Liquid crystal panel. 

Additionally, spillage from drink containers onto the 
device may cause smoke, fi re, electric shock and 
breakdown.

  Do not expose to strong impact.
   Impact such as dropping or hitting the device may 

cause breakdown or a fi re.

  Do not use the rear view camera except when 

  Do not connect more than one speaker to one 

  TO REDUCE THE RISK OF FIRE OR ELECTRIC 

  Use the specifi ed fuse. Be sure to always use the 

specifi ed fuse. If a fuse other than specifi ed fuse is 
used, it may cause a fi re or an accident. 

  Do not damage the cord by pinching or pulling it. 

Do not pull or damage the cord. If the cord is not 
treated properly, it will short out or be severed and 
may cause a fi re or an accident.

  When bending the mounting tab of the mounting 

collar with a screwdriver, be careful not to injure 
your hands and fi ngers.

  Various settings that have been stored in the 

memory in other on-board equipment may be lost if 
the battery terminals are disconnected.

   Therefore, we recommend you to make a record of 

or to back up the settings before disconnecting the 
terminals.

   After completing installation of the main unit, set up 

the equipment again according to the settings.

  Be sure to insulate any exposed wires from the car 

chassis. Bundle all cables and keep cable terminals 
free from any metal parts.

  Note that if your car has a driving computer or a 

navigation computer, disconnecting the cable from 
the battery may clear the memory.

  Run the cords avoiding the spots where the 

temperature can be extremely high.

  Route the cords of GPS antenna attached to the 

   If water seeps in the vehicle during rain or car 

washing, it could cause fi re or electric shock.

  Mount the navigation unit and the GPS antenna 

   Wipe the mounting area clean of dirt, wax etc., then 

fasten the camera securely in place. 

   Re-affi xing adhesive parts or use of general-purpose 

double-sided tape could cause weak bonding that 
would allow the equipment to drop off while the 
vehicle is in motion, causing accident or injury. 

   Check the state of bonding or mounting (loose 

screws etc.) occasionally.

  Never assign the “.mp3”, or “.wma” fi le name 





   THIS PRODUCT IS A CLASS I LASER PRODUCT. 

  Refer wiring and installation to qualifi ed service 

   Installation of this unit requires special skills and 

experience. For maximum safety, have it installed by 
your dealer. Panasonic is not liable for any problems 
resulting from your own installation of the unit.

  Follow the instructions to install and wire the 

   Not following the instructions to properly install and 

wire the product could cause an accident or fi re.

 Take care not to damage the leads.
   When wiring, take care not to damage the leads. 

Prevent them from getting caught in the vehicle 
chassis, screws, and moving parts such as seat rails. 
Do not scratch, pull, bend or twist the leads. Do not 
run them near heat sources or place heavy objects on 
them. If leads must be run over sharp metal edges, 
protect the leads by winding them with vinyl tape or 
similar protection.

  Use the designated parts and tools for installation.
   Use the supplied or designated parts and appropriate 

tools to install the product. The use of parts other than 
those supplied or designated may result in internal 
damage to the unit. Faulty installation may lead to an 
accident, a malfunction or fi re.

  Do not block the air vent or the cooling plate of the unit.
   Blocking these parts will cause the interior of the unit 

to overheat and will result in fi re or other damage.

  Do not install the product where it is exposed to 

   Avoid slanted or strongly curved surfaces for 

installation. If the installation is not stable, the unit 
may fall down while driving and this can lead to an 
accident or injury.

 Installation Angle
   The product should be installed in a horizontal 

position with the front end up at a convenient angle, 
but not more than 30°.

   The user should bear in mind that in some areas there 

may be restrictions on how and where this unit must 
be installed. Consult your dealer for further details.

  We strongly recommend that you wear gloves for 

  Make sure that wiring is completed before 

  To prevent damage to the unit, do not connect the 

  Never ground the speaker cords. For example, do not 

use a chassis ground system or a three-wire speaker 
common system. Each speaker must be connected 
separately using parallel insulated wires. If in doubt 
about how your car’s speakers are wired, please 
consult with your nearest professional installer.

FCC Warning:
Any unauthorized changes or modifi cations to this 
equipment would void the user’s authority to operate 
this device.



  Park your car in a safe place and apply the parking 

brake before watching the monitor. 



  A rear monitor (option) displays moving pictures 

while driving.



  Be sure to connect the parking brake connection 

lead. (





Installation Instructions)

4

5

5

4