Wintal pvr-x2 사용자 가이드

다운로드
페이지 44
44
10. Trouble Shooting 
Problem
Possible Causes
Remedy
No picture of sound
Incorrect audio and video 
setup
Make sure you have connected 
your PVR following the 
instructions on Setup
Incorrect antenna connection Make sure you have connected 
the antenna to the correct input 
on the back of your PVR
No signal, or weak signal 
due to poor signal strength
Ensure that your antenna is 
functioning properly. Contact your 
antenna installer if all else fails.
No signal or weak signal
Bad weather conditions like 
storms or lightning may cause a 
loss in signal quality.
Black and white picture AV cables may not be 
installed correctly
Make sure you your connections 
set up according to the 
instructions in this manual and 
also ensure cables are firmly 
connected to your TV and PVR
Remote control not 
working
Battery may be flat
Replace the batteries on your 
remoter
Too far from sensor
Come closer to the sensor 
located on your PVR
Battery is installed 
incorrectly
Make sure the batteries are 
installed correctly
Distorted TV picture
Your hi-fi speakers are to 
close to the TV
Magnetic distortion can be 
caused if speakers are placed too 
close to a TV set
Recording stops 
playing prematurely
A signal break up may have 
caused the program to stop 
recording
Bad weather may have caused 
the PVR to receive a weak signal 
that resulted in the recording 
being stopped.
Cannot record 2 
channels
The RF crossover cable is 
not connected
Ensure that you have the included 
RF crossover cable connected 
from the loop out 1 output to the 
Ant 2 input on your PVR
FIRMWARE UPDATE PROBLEMS
Unable to establish connection between computer and PVR using the RS-232 Serial Port
If you are not able to establish a working connection between your PC and PVR, make sure you 
have the communications port settings on your PC set up properly. 
You need to change the settings on your COM1 port using the device manager in windows. 
Make sure the bits per second is set to 115200 (right click on my computer -> manage -> device 
manager -> ports (COM & LPT) and check the port settings tab in the properties window of 
COM1)