3com 4200G 설치 가이드

1 

 

 

 

Figure 1  Appearance of an XFP interface module  

 

Figure 2  Front panel an XFP interface module  

Step 1: Put on an ESD-preventive wrist strap and verify it is properly 
grounded. Then remove the XFP interface module from the package. 

Step 2: Loosen the filler panel mounting screws on the rear panel of the 
switch with a screwdriver and remove the filler panel. 

Step 3: Hold the fastening screws on the front panel of the XFP interface 
module, and gently push the module in along the slot guide rail until the 
module is in close contact with the switch. 

Step 4: Tighten the fastening screws with a screwdriver to secure the XFP 
interface module.