3com 8807 참조 가이드
1018
C
HAPTER
60: I
NFORMATION
C
ENTER
By default, the information switch state of each channel is shown in Table 148:
n
If you only specify the level for one/two of the three types of information, the
level(s) of the unspecified two/one return(s) to the default. For example, if you only
define the level of the log information, then the levels of the trap and debugging
information return to the defaults.
level(s) of the unspecified two/one return(s) to the default. For example, if you only
define the level of the log information, then the levels of the trap and debugging
information return to the defaults.
channel-number: Channel number to be set.
channel-name: Channel name to be set. The name can be channel7, channel8,
channel9, console, logbuffer, loghost, monitor, snmpagent, trapbuffer,
logfile.
channel9, console, logbuffer, loghost, monitor, snmpagent, trapbuffer,
logfile.
state: Sets the state of the information.
state: Specifies the state as on or off.
Description
Use the info-center source command to add/delete a record to the information
channel.
channel.
Use the undo info-center source command to cancel the contents of the
information channel.
information channel.
Use this command to configure the information of log/trap/debugging type. For
example, for the filter of IP module log output, you can configure to output the
logs at a level higher than warnings to the log host and output those higher than
informational to the log buffer. You can also configure to output the trap
information on the IP module to a specified trap host, and so on.
example, for the filter of IP module log output, you can configure to output the
logs at a level higher than warnings to the log host and output those higher than
informational to the log buffer. You can also configure to output the trap
information on the IP module to a specified trap host, and so on.
The channels for filtering in all the directions are specified by this configuration
command. All the information will be sent to the corresponding directions
through the specified channels. You can configure the channels in the output
direction, channel filter information, filtering and redirecting of all kinds of
information.
command. All the information will be sent to the corresponding directions
through the specified channels. You can configure the channels in the output
direction, channel filter information, filtering and redirecting of all kinds of
information.
Table 148 Default information switch state of each channel
Channel
Log information
switch
switch
Trap information
switch
switch
Debug information
switch
switch
Console
Enable
Disable
Enable
Terminal
Enable
Disable
Enable
Log host
Enable
Enable
Disable
Trapbuffer
Disable
Enable
Disable
Logbuffer
Enable
Disable
Disable
SNMPagent
Disable
Enable
Disable
Logfile
Enable
Disable
Disable
Channel7
Enable
Enable
Disable
Channel8
Enable
Enable
Disable
Channel9
Enable
Enable
Disable