3com 8807 참조 가이드
138
C
HAPTER
10: E
THERNET
P
ORT
C
ONFIGURATION
C
OMMANDS
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] link-status hold 5
interface
Syntax
interface interface-type interface-number
View
System view
Parameter
interface-type: Specifies the port type. It can be Aux, Ethernet, Loopback,
M-Ethernet, NULL, VLAN-interface, GigabitEthernet or 10-GigabitEthernet.
M-Ethernet, NULL, VLAN-interface, GigabitEthernet or 10-GigabitEthernet.
interface-number: Specifies the port number. It adopts
slot-number/subslot-number/ port-number format. slot-number specifies the I/O
Module slot number of the port. For Switch 8807, it ranges from 2 to 6. For
Switch 8810, it ranges from 0 to 3 and 6 to 9 (slot number 4 and 5 are Fabric). For
Switch 8814, it ranges from 0 to 5 and 8 to 13 (slot number 6 and 7 are Fabric).
subslot-number specifies the sub-slot number of the port and ranges from 1 to 3.
port-number specifies the port number on the daughter card. It is 1 or ranges
from 1 to 12, 20, or 48, depending on the module type. M-Ethernet is used to
update and maintain. It ranges from 0/0/0.
slot-number/subslot-number/ port-number format. slot-number specifies the I/O
Module slot number of the port. For Switch 8807, it ranges from 2 to 6. For
Switch 8810, it ranges from 0 to 3 and 6 to 9 (slot number 4 and 5 are Fabric). For
Switch 8814, it ranges from 0 to 5 and 8 to 13 (slot number 6 and 7 are Fabric).
subslot-number specifies the sub-slot number of the port and ranges from 1 to 3.
port-number specifies the port number on the daughter card. It is 1 or ranges
from 1 to 12, 20, or 48, depending on the module type. M-Ethernet is used to
update and maintain. It ranges from 0/0/0.
Description
Use the interface command to enter various types of Ethernet port views.
Before you can configure the related parameters of a type of Ethernet port, you
must first use this command to enter the Ethernet port view of this type.
must first use this command to enter the Ethernet port view of this type.
Example
# Enter the Ethernet2/1/1 port view.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] interface ethernet2/1/1
jumboframe enable
Syntax
jumboframe enable [ jumboframe-value ] slot slot-num
undo jumboframe enable
View
System view
Parameter
slot-num: Specifies the slot number of the card.
jumboframe-value: specifies the maximum size of jumbo frames permitted to pass
the card.
the card.