3com 8807 참조 가이드
600
C
HAPTER
34: S
TATIC
M
ULTICAST
MAC A
DDRESS
C
ONFIGURATION
C
OMMAND
The PIM protocol must not be enabled on the corresponding virtual interface of
the specified VLAN.
the specified VLAN.
Related command: display mac-address multicast static.
Example
# Add a new multicast MAC address. The MAC address is 0100-1000-1000. Ports
are from Ethernet 1/1/1 to Ethernet 1/1/5, and these ports belong to Vlan 2
are from Ethernet 1/1/1 to Ethernet 1/1/5, and these ports belong to Vlan 2
[SW8800] mac-address multicast 0100-1000-1000 interface Ethernet 1/1
/1 to Ethernet 1/1/5 vlan 2
display mac-address
multicast static
Syntax
display mac-address multicast static [ [ mac-addr ] vlan vlan-id ]
View
Any view
Parameter
mac-addr: Multicast MAC address.
vlan-id: ID of the VLAN.
Description
Use the display mac-address multicast static command to display the
information of a static multicast group. The information includes multicast MAC
address, VLAN ID, address status, port name, and aging time.
information of a static multicast group. The information includes multicast MAC
address, VLAN ID, address status, port name, and aging time.
If all ports in the configured static multicast MAC group are out of position (the
corresponding module has been pulled out after configuration), the port name in
the MAC information is displayed as N/A when you use this command.
corresponding module has been pulled out after configuration), the port name in
the MAC information is displayed as N/A when you use this command.
Example
# Display all static multicast MAC address information
<SW8800> display mac-address multicast static
MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s)
0100-5e01-0101 3 Config static Ethernet0/1/23 N/A
Ethernet0/1/24
--- 1 mac address(es) found ---
Table 84 Description on the fields of display mac-address multicast static
Field
Description
MAC ADDR
Multicast MAC address
VLAN ID
The ID of the VLAN where the MAC address is located.
STATE
Status of MAC address.
The status of the static multicast MAC address is always "Config static".
PORT INDEX
Port name.
When no valid port is in position, the port name is displayed as N/A
AGING TIME(s)
Aging time.
The aging time of a static multicast MAC address is always "N/A".