3com 8807 사용자 가이드
VPLS Basic Configuration
639
Configuring Routing
Protocols
You must perform some basic routing configuration on your switch such that it
can exchange routing information with other P and PE devices. Currently, you can
choose the following routing protocols: static routing, routing information
protocol (RIP), open shortest path first (OSPF), exterior border gateway protocol
(EBGP), and so on. For specific configuration, refer to Switch 8800 Family Series
Routing Switches Operation Manual - Routing Protocol.
can exchange routing information with other P and PE devices. Currently, you can
choose the following routing protocols: static routing, routing information
protocol (RIP), open shortest path first (OSPF), exterior border gateway protocol
(EBGP), and so on. For specific configuration, refer to Switch 8800 Family Series
Routing Switches Operation Manual - Routing Protocol.
Configuring Basic MPLS
Functions
Configure basic MPLS functions to create LSP tunnels over public network. For
specific configuration, refer to the "MPLS" section in 3Com Switch 8800 Family
Series Routing Switches Operation Manual Volume I.
specific configuration, refer to the "MPLS" section in 3Com Switch 8800 Family
Series Routing Switches Operation Manual Volume I.
Configuring LDP
Expansion Session Peer
Configure LDP remote peer to set up LDP remote session.
Entering the remote-peer mode
Perform the following configuration in system view.
By default, no remote peer exists.
Configuring an address for the remote peer
You can specify any LDP-enabled interface address of a remote peer device or the
loopback address of a label switch router (LSR) that has advertised its routing
information as the address of the remote peer.
loopback address of a label switch router (LSR) that has advertised its routing
information as the address of the remote peer.
Perform the following configuration in remote-peer view.
Enabling L2VPN
Enable L2VPN globally before you configure VPLS and VLL; otherwise you cannot
configure VPLS and VLL.
configure VPLS and VLL.
Perform the following configuration in system view.
By default, MPLS L2VPN is disabled.
Table 570 Enter the remote-peer mode
Operation
Command
Enter the remote-peer mode
mpls ldp remote-peer index
Remove the remote peer
undo mpls ldp remote-peer index
Table 571 Configure an address for the remote peer
Operation
Command
Configure an address for the remote peer
remote-ip remoteip
Table 572 Enable L2VPN
Operation
Command
Enable MPLS L2VPN
mpls l2vpn
Disable MPLS L2VPN
undo mpls l2vpn