3com 8807 사용자 가이드
VLAN-VPN Tunnel Configuration
859
# Disable the STP protocol and enable VLAN-VPN on Ethernet3/1/3.
[Switch_D] interface Ethernet3/1/2
[Switch_D-Ethernet3/1/2] stp disable
[Switch_D-Ethernet3/1/2] vlan-vpn enable
[Switch_D-Ethernet3/1/2] quit
# Set Ethernet3/1/3 to a trunk port and add this port to all the VLANs.
[Switch_D] interface Ethernet3/1/3
[Switch_D-Ethernet3/1/3] port link-type trunk
[Switch_D-Ethernet3/1/3] port trunk permit vlan all
c
CAUTION:
■
STP must be enabled on VLAN-VPN tunnel-enabled devices; otherwise BPDUs
in the user network cannot be transmitted transparently.
in the user network cannot be transmitted transparently.
■
VLAN-VPN-enabled ports must be configured to Access ports. The link type of
the intermediate operator’s network must be configured to the Trunk link.
the intermediate operator’s network must be configured to the Trunk link.
■
You cannot configure VLAN-VPN tunnel on the ports where DOT1X, GVRP, STP,
or NTDP is enabled.
or NTDP is enabled.