3com 8807 사용자 가이드
426
C
HAPTER
39: IGMP S
NOOPING
C
ONFIGURATION
■
When you configure IGMP Snooping fast leave on aggregation ports, the
configuration takes effect only on primary aggregation ports.
configuration takes effect only on primary aggregation ports.
■
If you add an IGMP V1 host of the same multicast group to the port, the switch
does not remove the port when the port receives an IGMP Leave packet of the
multicast group even you enable IGMP Snooping fast leave for the port.
does not remove the port when the port receives an IGMP Leave packet of the
multicast group even you enable IGMP Snooping fast leave for the port.
Multicast Static
Routing Port
Configuration
Routing Port
Configuration
Introduction
By configuring a port in a VLAN to be a static routing port, you can enable IGMP
packets to be transparently transmitted through the port, meeting the
requirements of specific networks.
packets to be transparently transmitted through the port, meeting the
requirements of specific networks.
Prerequisites
■
Ports and VLANs involved already exist.
■
Ports to be configured belong to corresponding VLANs.
Configuring a Multicast
Static Routing Port
You can configure a port in a VLAN to be a static routing port in VLAN view.
You can also configure a port in a VLAN to be a static routing port in the
corresponding Ethernet port view.
corresponding Ethernet port view.
c
CAUTION:
■
You will fail to configure a port to be a static routing port if the port identified
by the port-number argument does not exist, or the port does not belong to
the VLAN.
by the port-number argument does not exist, or the port does not belong to
the VLAN.
Table 418 Configure a port in a VLAN to be a static routing port in VLAN view
Operation
Command
Remarks
Enter system view
system-view
-
Enter VLAN view
vlan vlan-id
-
Configure multicast static
routing port
routing port
multicast static-router-port
port-number
port-number
Provide the port-number
argument in the format of
interface-type
interface-number, where the
interface-type argument can
only be Ethernet port type.
argument in the format of
interface-type
interface-number, where the
interface-type argument can
only be Ethernet port type.
By default, no static routing
port is configured.
port is configured.
Table 419 Configure a port in a VLAN to be a static routing port in Ethernet port view
Operation
Command
Remarks
Enter system view
system-view
-
Enter Ethernet port view
interface interface-type
interface-number
interface-number
The interface-type argument
can only be Ethernet port
type.
can only be Ethernet port
type.
Configure multicast static
routing port
routing port
multicast static-router-port
vlan vlan-id
vlan vlan-id
By default, no static routing
port is configured.
port is configured.