3com S7906E 설치 설명서
1-33
(10.110.3.100, 225.1.1.0) 1.1.1.1 ? ? 02:03:30 00:05:31
(10.110.3.100, 225.1.1.1) 1.1.1.1 ? ? 02:03:30 00:05:31
(10.110.3.100, 225.1.1.2) 1.1.1.1 ? ? 02:03:30 00:05:31
(10.110.3.100, 225.1.1.3) 1.1.1.1 ? ? 02:03:30 00:05:31
(10.110.3.100, 226.1.1.0) 1.1.1.1 ? ? 02:03:30 00:05:31
(10.110.3.100, 226.1.1.1) 1.1.1.1 ? ? 02:03:30 00:05:31
(10.110.3.100, 226.1.1.2) 1.1.1.1 ? ? 02:03:30 00:05:31
(10.110.3.100, 226.1.1.3) 1.1.1.1 ? ? 02:03:30 00:05:31
# View the (S, G) entries cached in the SA cache on Switch D.
[SwitchD] display msdp sa-cache
MSDP Source-Active Cache Information of VPN-Instance: public net
MSDP Total Source-Active Cache - 4 entries
MSDP matched 4 entries
(Source, Group) Origin RP Pro AS Uptime Expires
(10.110.3.100, 226.1.1.0) 1.1.1.1 ? ? 00:32:53 00:05:07
(10.110.3.100, 226.1.1.1) 1.1.1.1 ? ? 00:32:53 00:05:07
(10.110.3.100, 226.1.1.2) 1.1.1.1 ? ? 00:32:53 00:05:07
(10.110.3.100, 226.1.1.3) 1.1.1.1 ? ? 00:32:53 00:05:07
Troubleshooting MSDP
MSDP Peers Stay in Down State
Symptom
The configured MSDP peers stay in the down state.
Analysis
z
A TCP connection–based MSDP peering relationship is established between the local interface
address and the MSDP peer after the configuration.
z
The TCP connection setup will fail if there is a consistency between the local interface address and
the MSDP peer address configured on the router.
z
If no route is available between the MSDP peers, the TCP connection setup will also fail.
Solution
1) Check that a route is available between the routers. Carry out the display ip routing-table
command to check whether the unicast route between the routers is correct.
2) Check that a unicast route is available between the two routers that will become MSDP peers to
each other.
3) Verify the interface address consistency between the MSDP peers. Use the display
current-configuration command to verify that the local interface address and the MSDP peer
address of the remote router are the same.