3com S7906E 설치 설명서

 

1-40 

# On Switch E, configure the service scope of RP advertisements, specify a C-BSR and a C-RP, and set 

the hash mask length to 128 and the priority of the C-BSR to 20.  

<SwitchE> system-view 

[SwitchE] acl ipv6 number 2005 

[SwitchE-acl6-basic-2005] rule permit source ff0e::101 64 

[SwitchE-acl6-basic-2005] quit 

[SwitchE] pim ipv6 

[SwitchE-pim6] c-bsr 1003::2 128 20 

[SwitchE-pim6] c-rp 1003::2 group-policy 2005 

[SwitchE-pim6] quit 

4)  Verify the configuration 

Use the display pim ipv6 interface command to view the IPv6 PIM configuration and running status on 

each interface. For example:  

# View the IPv6 PIM information on all interfaces of Switch A.  

[SwitchA] display pim ipv6 interface 

 Interface            NbrCnt HelloInt   DR-Pri    DR-Address 

 Vlan100              0      30         1         1001::1 

                                                  (local) 

 Vlan101              1      30         1         1002::2 

 Vlan102              1      30         1         1003::2 

To view the BSR election information and the locally configured C-RP information in effect on a switch, 

use the display pim ipv6 bsr-info command. For example:  

# View the BSR information and the locally configured C-RP information in effect on Switch A. 

[SwitchA] display pim ipv6 bsr-info 

 Elected BSR Address: 1003::2 

     Priority: 20 

     Hash mask length: 128 

     State: Accept Preferred 

     Uptime: 00:04:22 

     Expires: 00:01:46 

# View the BSR information and the locally configured C-RP information in effect on Switch D. 

[SwitchD] display pim ipv6 bsr-info 

 Elected BSR Address: 1003::2 

     Priority: 20 

     Hash mask length: 128 

     State: Elected 

     Uptime: 00:05:26 

     Expires: 00:01:45 

 Candidate BSR Address: 4002::1 

     Priority: 10 

     Hash mask length: 128 

     State: Candidate 

 

 Candidate RP: 4002::1(Vlan-interface105) 

     Priority: 0