3com S7906E 설치 설명서

 

1-17 

This configuration allows you to change the source IPv6 address of MLD queries.  

Follow these steps to configure source IPv6 addresses of MLD queries:  

Enter system view 

— 

Enter VLAN view 

vlan vlan-id 

— 

Configure the source IPv6 
address of MLD general 
queries  

mld-snooping general-query 
source-ip { ipv6-address | 
current-interface } 

Optional 

FE80::02FF:FFFF:FE00:0001 
by default 

Configure the source IPv6 
address of MLD 
multicast-address-specific 
queries  

mld-snooping special-query 
source-ip { ipv6-address | 
current-interface } 

Optional 

FE80::02FF:FFFF:FE00:0001 
by default 

 

The source IPv6 address of MLD query messages may affect MLD querier election within the segment.  

 

Before configuring MLD snooping proxying in a VLAN, enable MLD snooping in the VLAN and prepare 

the following data: 

z 

Source IPv6 address for the MLD reports sent by the proxy 

z 

Source IPv6 address for the MLD done messages sent by the proxy 

The MLD snooping proxying function works on a per-VLAN basis. After you enable the function in a 

VLAN, the device works as the MLD snooping proxy for the downstream hosts and upstream router in 

the VLAN.  

Follow these steps to enable MLD snooping proxying in a VLAN:  

Enter system view 

system-view 

— 

Enter VLAN view 

vlan vlan-id 

— 

Enable MLD snooping 
proxying in the VLAN 

Required 

Disabled by default.