3com S7906E 설치 설명서

1-12

Figure 1-5 Network diagram for port-based IPv6 multicast VLAN configuration

Source

Receiver

Host A

VLAN 2

GE2/0/2

GE2/0/3

GE2/0/4

Switch A

MLD querier

Router A

GE2/0/1

1:2/64

GE2/0/2
2001::1/64

1::1/64

Receiver

Host B

VLAN 3

Receiver

Host C

VLAN 4

GE2/0/1

Configuration procedure

1) Enable IPv6 forwarding and configure IPv6 addresses

Enable IPv6 forwarding on each device and configure the IPv6 address and address prefix for each

interface as per

Figure 1-5

. The detailed configuration steps are omitted here.

2) Configure Router A

# Enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable MLD on the

host-side interface GigabitEthernet 2/0/2.

<RouterA> system-view

[RouterA] multicast ipv6 routing-enable

[RouterA] interface gigabitethernet 2/0/1

[RouterA-GigabitEthernet2/0/1] ipv6 pim dm

[RouterA-GigabitEthernet2/0/1] quit

[RouterA] interface gigabitethernet 2/0/2

[RouterA-GigabitEthernet2/0/2] ipv6 pim dm

[RouterA-GigabitEthernet2/0/2] mld enable

3) Configure Switch A

# Enable MLD Snooping globally.

<SwitchA> system-view

[SwitchA] mld-snooping

[SwitchA-mld-snooping] quit

# Create VLAN 10, assign GigabitEthernet 2/0/1 to VLAN 10, and enable MLD Snooping in this VLAN.

[SwitchA] vlan 10

[SwitchA-vlan10] port gigabitethernet 2/0/1

[SwitchA-vlan10] mld-snooping enable

[SwitchA-vlan10] quit

# Create VLAN 2 and enable MLD Snooping in the VLAN.