3com S7906E 설치 설명서

 

1-30 

Check the validity and 
reachability of an MPLS LSP 

[ -a source-ip | -c 

 | -exp exp-value | -h 

 | -m wait-time | -r 

reply-mode 

| -s packet-size | -t 

 | -v ] * { ipv4 dest-addr 

mask-length 
[ destination-ip-addr-header ] | 
te interface-type 
interface-number 

} 

Available in any view 

Locate an MPLS LSP error 

[-a source-ip | -exp 

 | -h ttl-value | -r 

reply-mode |-t time-out

 ] * 

{ ipv4 dest-addr mask-length 
[ destination-ip-addr-header ] | 
te interface-type 
interface-number 

} 

Available in any view 

 

With the MPLS trap function enabled, trap packets of the notifications level will be generated to report 
critical MPLS events. Such trap packets will be sent to the information center of the device. Whether 
and where the packets will then be output depend on the configurations of the information center. For 
information on how to configure the information center, refer to Information Center Configuration in the 

. 

Follow these steps to enable the MPLS trap function: 

Enter system view 

— 

Enable the MPLS trap function  snmp-agent trap enable mpls

Required 
Disabled by default 

 

For detailed information about the snmp-agent trap enable mpls command, refer to the snmp-agent 

 command in SNMP Commands of the System Volume.