3com S7906E 설치 설명서

 

1-10 

Configure the reserve VLAN for 
MPLS L2VPN 

mpls l2vpn reserve vlan 
vlan-id 

Optional 

If the SRPU is LSQ1SRP1CB, 
you can enable MPLS L2VPN 
only after you configure the 
mpls l2vpn reserve vlan 
command. 

Enable MPLS L2VPN 

Required 

 

z 

Configuring IGP on the PEs and P devices to guarantee the IP connectivity of the MPLS backbone 

z 

Configuring MPLS basic capability for the MPLS backbone on the PEs and P devices 

z 

Configuring MPLS L2VPN 

When creating an LDP VPLS instance, you need to perform the following configurations: 

1)  Specify a globally unique name for the VPLS instance and set the peer discovery mechanism to 

manual configuration. 

2)  Configure LDP as the signaling protocol to be used. This is because in L2VPN implementation, the 

Martini mode uses extended LDP (remote LDP sessions) as the signaling for transferring PW 

information. Therefore, the LDP mode is also called the Martini mode. 

3)  Specify the ID of the VPLS instance. 

4) Use 

the 

peer command to create the VPLS peer PE for the instance, specifying: 

z 

IP address of the peer PE. 

z 

ID of the PW to the peer PE, which must be consistent with that specified on the peer PE.  

z 

Type of the peer PE. A peer of the UPE type is a user access convergence device in the H-VPLS 

model. For a UPE, you can configure one and only one NPE peer as the backup peer of the UPE.  

z 

PW class template to be referenced. A PW class template defines the PW transport mode and 

tunneling policy to be used. 

5)  Configuring primary-backup PW switchback: M ake sure that the configurations on the related UPE 

and NPE devices are consistent, including whether to enable PW switchback and if yes, the 

switchback delay time.  

 

For information about Martini mode, refer to MPLS L2VPN Configuration in the MPLS Volume. 

 

Follow these steps to configure an LDP VPLS instance: