3com S7906E 설치 설명서

 

1-14 

 

z 

Do not configure both the dsap-id and ssap-id arguments in the protocol-vlan command as 0xe0 

or 0xff when configuring the user-defined template for llc encapsulation. Otherwise, the 

encapsulation format of the matching packets will be the same as that of the ipx llc or ipx raw 

packets respectively. 

z 

When you use the mode keyword to configure a user-defined protocol template, do not set etype-id 

in ethernetii etype etype-id to 0x0800, 0x8137,  0x809b, or 0x86dd. Otherwise, the encapsulation 

format of the matching packets will be the same as that of the IPv4, IPX, AppleTalk, and IPv6 

packets respectively. 

z 

A protocol-based VLAN on a hybrid port can process only untagged inbound packets, whereas the 

voice VLAN in automatic mode on a hybrid port can process only tagged voice traffic. Therefore, do 

not configure a VLAN as both a protocol-based VLAN and a voice VLAN. For more information, 

.  

z 

After you configure a command on a Layer 2 aggregate interface, the system starts applying the 

configuration to the aggregate interface and its aggregation member ports. If the system fails to do 

that on the aggregate interface, it stops applying the configuration to the aggregation member ports. 

If it fails to do that on an aggregation member port, it simply skips the port and moves to the next 

port.  

 

In this approach, packets are assigned to VLANs based on their source IP addresses and subnet masks. 

A port configured with IP subnet-based VLANs assigns a received untagged packet to a VLAN based on 

the source address of the packet.  

This feature is used to assign packets from the specified network segment or IP address to a specific 

VLAN.  

 

This feature is only applicable on hybrid ports. 

Follow these steps to configure an IP subnet-based VLAN: 

Enter system view 

— 

Enter VLAN view 

vlan vlan-id 

—