3com S7906E 설치 설명서
1-23
Figure 1-8 Network diagram for configuring H-VPLS using LSP
Loo
p0
3
.3.3.3/32
L
oop0
1.1
.1.1/32
.1.1/32
Configuration procedure
1) Configure the IGP protocol on the MPLS backbone, which is OSPF in this example. The detailed
configuration steps are omitted.
2) Configure
UPE
# Configure MPLS basic capability.
<Sysname> system-view
[Sysname] sysname UPE
[UPE] interface loopback 0
[UPE-LoopBack0] ip address 1.1.1.1 32
[UPE-LoopBack0] quit
[UPE] mpls lsr-id 1.1.1.1
[UPE] mpls
[UPE-mpls] quit
[UPE] mpls ldp
[UPE-mpls-ldp] quit
# Configure MPLS basic capability on the interface connected with NPE 1.
[UPE] interface vlan-interface 12
[UPE-Vlan-interface12] ip address 12.1.1.1 24
[UPE-Vlan-interface12] mpls
[UPE-Vlan-interface12] mpls ldp
[UPE-Vlan-interface12] quit
# Configure the remote LDP session with NPE 1.
[UPE] mpls ldp remote-peer 1
[UPE-mpls-remote-1] remote-ip 2.2.2.2
[UPE-mpls-remote-1] quit
# Configure the remote LDP session with NPE 2.
[UPE] mpls ldp remote-peer 2
[UPE-mpls-remote-1] remote-ip 3.3.3.3
[UPE-mpls-remote-1] quit
# Configure MPLS L2VPN.