3com S7906E 설치 설명서
1-28
Configuration Prerequisites
The configurations described in this section need to be used together with the dynamic signaling
protocol RSVP-TE.
protocol RSVP-TE.
Before performing them, be aware of each configuration objective and its impact on your system.
Configuration Procedures
Tuning MPLS TE tunnel setup involves these tasks:
z
z
z
z
Configuring loop detection
Follow these steps to configure loop detection:
To do…
Use the command...
Remarks
Enter system view
system-view
––
Enter MPLS TE tunnel interface
view
view
interface
tunnel
tunnel-number
––
Enable the system to perform
loop detection when setting up
a tunnel
loop detection when setting up
a tunnel
mpls te loop-detection
Required
Disabled by default
Disabled by default
Submit current tunnel
configuration
configuration
mpls te commit
Required
Configuring route and label recording
Follow these steps to configure route and label recording:
To do…
Use the command...
Remarks
Enter system view
system-view
––
Enter MPLS TE tunnel
interface view
interface view
interface tunnel
tunnel-number
––
Record
routes
routes
mpls te record-route
Enable the
system to
record
routes or
label
bindings
when
setting up
the tunnel
system to
record
routes or
label
bindings
when
setting up
the tunnel
Record
routes and
label
bindings
routes and
label
bindings
mpls te record-route label
Required
Use either of the commands.
Both route recording and label
binding recording are disabled by
default.
Use either of the commands.
Both route recording and label
binding recording are disabled by
default.
Submit current tunnel
configuration
configuration
mpls te commit
Required