3com S7906E 설치 설명서

 

1-30 

Follow these steps to configure the attributes related to data to be sent to the RADIUS server: 

Enter system view 

— 

Enter RADIUS scheme view 

radius scheme 
radius-scheme-name 

— 

Specify the format of the 
username to be sent to a 
RADIUS server 

user-name-format 
{ keep-original

 | 

with-domain | 

without-domain } 

Optional 

By default, the ISP domain 
name is included in the 
username. 

Specify the unit for data flows or 
packets to be sent to a RADIUS 
server 

data-flow-format { data { byte 
| giga-byte | kilo-byte | 
mega-byte } | packet 
{ giga-packet | kilo-packet | 
mega-packet | one-packet } }*

Optional 

The defaults are as follows: 

byte for data flows, and 
one-packet for data packets. 

 

z 

Some earlier RADIUS servers cannot recognize usernames that contain an ISP domain name. In 

this case, the device must remove the domain name before sending a username including a 

domain name. You can configure the user-name-format  without-domain  command on the 

device for this purpose. 

z 

If a RADIUS scheme defines that the username is sent without the ISP domain name, do not apply 

the RADIUS scheme to more than one ISP domain. Otherwise, users using the same username 

but in different ISP domains will be considered the same user. 

z 

For level switching authentication, the user-name-format keep-original and user-name-format 

without-domain commands produce the same results, that is, usernames sent to the RADIUS 

server carry no ISP domain name.  

z 

The unit of data flows sent to the RADIUS server must be consistent with the traffic statistics unit of 

the RADIUS server. Otherwise, accounting cannot be performed correctly. 

 

If a NAS sends an accounting or authentication request to the RADIUS server but gets no response, the 

NAS retransmits the request. With the RADIUS trap function enabled, when the NAS transmits the 

request for half of the specified maximum number of transmission attempts, it sends a trap message; 

when the NAS transmits the request for the specified maximum number of transmission attempts, it 

sends another trap message. 

Follow these steps to enable the RADIUS trap function: 

Enter system view 

— 

Enable the RADIUS trap 
function 

radius trap 
{ accounting-server-down | 
authentication-server-down } 

Required 

Disabled by default