3com S7906E 설치 설명서

 

2-2 

When the device functions as the SFTP server, only one client can access the SFTP server at a time. If 

the SFTP client uses WinSCP, a file on the server cannot be modified directly; it can only be 

downloaded to a local place, modified, and then uploaded to the server. 

 

Configuring the SFTP Connection Idle Timeout Period 

Once the idle period of an SFTP connection exceeds the specified threshold, the system automatically 

tears the connection down, so that a user cannot occupy a connection for nothing. 

Follow these steps to configure the SFTP connection idle timeout period: 

Enter system view 

— 

Configure the SFTP connection 
idle timeout period 

sftp server idle-timeout 
time-out-value 

Optional 

10 minutes by default 

 

Configuring an SFTP Client 

Specifying a Source IP Address or Interface for the SFTP Client 

You can configure a client to use only a specified source IP address or interface to access the SFTP 

server, thus enhancing the service manageability.   

Follow these steps to specify a source IP address or interface for the SFTP client: 

Enter system view 

— 

Specify a 
source IPv4 
address or 
interface for 
the SFTP 
client 

sftp client source { ip 
ip-address | interface 
interface-type 
interface-number }  

Specify a 
source IP 
address or 
interface for 
the SFTP 
client 

Specify a 
source IPv6 
address or 
interface for 
the SFTP 
client 

sftp client ipv6 source { ipv6 
ipv6-address | interface 
interface-type 
interface-number } 

Required 

Use either command. 

By default, an SFTP client uses 
the interface address specified 
by the route of the device to 
access the SFTP server. 

 

Establishing a Connection to the SFTP Server 

This configuration task is to enable the SFTP client to establish a connection with the remote SFTP 

server and enter SFTP client view. 

Follow these steps to enable the SFTP client: