3com S7906E 설치 설명서
1-6
z
A smart link device is a device that supports Smart Link and is configured with a smart link group
and a transmit control VLAN for flush message transmission. Device C and Device D in
are two examples of smart link devices.
z
An associated device is a device that supports Smart Link, and receives flush messages sent from
the specified control VLAN. Device A, Device B, and Device E in
are examples of
associated devices.
Configuring a Smart Link Device
Configuration Prerequisites
z
Before configuring a port as a smart link group member, shut down the port to prevent loops. You
can bring up the port only after completing the smart link group configuration.
z
Disable STP and RRPP on the ports you want to add to the smart link group, and make sure that
the ports are not member ports of any aggregation group or service loopback group.
A loop may occur on the network during the time when STP is disabled but Smart Link has not yet taken
effect on a port.
Configuring Protected VLANs for a Smart Link Group
Follow these steps to configure the protected VLANs for a smart link group:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create a smart link group and enter
smart link group view
smart link group view
smart-link group group-id
—
Configure protected VLANs for the
smart link group
smart link group
protected-vlan reference-instance
instance-id-list
instance-id-list
Required
By default, no
protected VLAN is
configured for a smart
link group.
protected VLAN is
configured for a smart
link group.
The protected-vlan command configures protected VLANs for a smart link group by referencing MSTIs.
To view VLAN-to-MSTI mappings, use the display stp region-configuration command. For
VLAN-to-MSTI mapping configuration, refer to MSTP Configuration in the Access Volume.