3com S7906E 설치 설명서

 

4-2 

AT&K0   

----------------------- Disable flow control 

AT&R1   

----------------------- Ignore RTS signal 

AT&S0   

----------------------- Set DSR to high level by force 

ATEQ1&W 

----------------------- Disable the modem from returning command response and the 

result, save the changes 

You can verify your configuration by executing the AT&V command. 

 

The above configuration is unnecessary to the modem on the administrator side. 

The configuration commands and the output of different modems may differ. Refer to the user manual 

of the modem when performing the above configuration. 

 

 

After logging in to a switch through its Console port by using a modem, you will enter the AUX user 

interface. The corresponding configuration on the switch is the same as those when logging in to the 

switch locally through its Console port except that: 

z 

When you log in through the Console port using a modem, the baud rate of the Console port is 

usually set to a value lower than the transmission speed of the modem. Otherwise, packets may 

get lost. 

z 

Other settings of the Console port, such as the check mode, the stop bits, and the data bits, remain 

the default. 

 

The configuration on the switch depends on the authentication mode the user is in. Refer to 

 

for the information about authentication mode configuration. 

Refer to 

.

 

Refer to 

. 

Refer to 

. 

Step 1: Configure the user name and password on the switch. Refer to 

, 

Console Port Login Configuration with