3com S7906E 설치 설명서
1-15
To do…
Use the command…
Remarks
Enter system view
system-view
—
Configure the working mode of
an EA LPU
an EA LPU
switch-mode { bridging |
routing } slot slot-number
routing } slot slot-number
Optional
By default, the working mode of
an EA LPU is determined by
the SRPU model and the
current traffic forwarding mode
of the SRPU. Refer to
an EA LPU is determined by
the SRPU model and the
current traffic forwarding mode
of the SRPU. Refer to
for details.
Table 1-2 Default working mode of EA LPUs
SRPU model
Current traffic forwarding
mode of the SRPU
Default working mode of EA
LPUs
LSQ1SRP2XB
LSQ1SRPB
LSQ1MPUA
LSQ1CGV24PSC
LSQ1CGP24TSC
LSQ1SRPD
LSQ1SRP12GB
l2-enhanced or standard
routing
l2-enhanced or
standard-bridging
standard-bridging
bridging
LSQ1SRP1CB
standard-routing
routing
z
When the SRPU of the S7900E switch is LSQ1SRP1CB, it is recommended not to modify the
default working mode the EA LPUs as other modes.
z
When the SRPU of the S7900E switch is LSQ1SRP2XB, LSQ1SRPB, LSQ1MPUA,
LSQ1CGP24TSC, LSQ1CGV24PSC, LSQ1SRPD or LSQ1SRP12GB, if an EA LPU is connected
to a Layer 2 forwarding network with a large number of MAC addresses, you can modify the
working mode of the EA LPU from the default to the MAC extension mode.
z
EA LPUs, like LSQ1GP12EA and LSQ1TGX1EA, do not support IPv6 and IRF.
z
To make the configured working mode take effect, you need to save the configuration and restart
the LPU.
Configuring the Working Mode of EB and SD LPUs
Follow these steps to configure the working mode of an EB or SD LPU:
To do…
Use the command…
Remarks
Enter system view
system-view
—