3com S7906E 설치 설명서
1-13
To do…
Use the command…
Remarks
Configure common optional
parameters
parameters
Refer to
Optional
The number of probes made in a UDP jitter test depends on the probe count command, while the
number of probe packets sent in each probe depends on the configuration of the probe
packet-number command.
Configuring an SNMP Test
An SNMP query test is used to test the time the NQA client takes to send an SNMP query packet to the
SNMP agent and then receive a response packet.
Configuration prerequisites
The SNMP agent function must be enabled on the device serving as an SNMP agent before an SNMP
test. For the configuration of SNMP agent, refer to SNMP Configuration in the System Volume.
Configuring an SNMP test
Follow these steps to configure an SNMP test:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter NQA test group view
nqa entry admin-name
operation-tag
operation-tag
—
Configure the test type as
SNMP and enter test type view
SNMP and enter test type view
type snmp
Required
Configure the destination
address for a test operation
address for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
address is configured for a test
operation.
Specify the source port number
for a probe request in a test
operation
for a probe request in a test
operation
source port port-number
Optional
By default, no source port number
is specified.
is specified.
Configure the source IP
address of a probe request in a
test operation
address of a probe request in a
test operation
source ip ip-address
Optional
By default, no source IP address
is specified.
is specified.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.
Configure common optional
parameters
parameters
Optional