3com S7906E 설치 설명서

 

1-15 

z 

A mirroring group contains only one monitor port.  

z 

To ensure that the port mirroring function can work properly, do not enable STP, MSTP, or RSTP 

on the monitor port. 

z 

You are recommended to use a monitor port only for port mirroring. This is to ensure that the data 

monitoring device receives and analyzes only the mirrored traffic rather than a mix of mirrored 

traffic and normally forwarded traffic. 

z 

A port connected to an RRPP ring cannot be configured as the monitor port of a port mirroring 

group. 

 

An S7900E switch installed with an OLT card can work as an OLT in an EPON system. For detailed 

information about an EPON system, refer to the Introduction to EPON System part in EPON-OLT 

Configuration.  

In an EPON system, an OLT can remotely manage and maintain ONUs. An S7900E switch can 

configure local port mirroring for ONUs to mirror the incoming or outgoing traffic of an UNI of an ONU to 

another UNI of the ONU. 

Follow these steps to configure local port mirroring for UNIs: 

Enter system view 

system-view 

— 

Enter ONU port view 

interface interface-type 
interface-number 

— 

Configure a mirroring port 
and the traffic direction to be 
monitored 

uni uni-number mirroring-port 
{ both | inbound | outbound } 

Required 

Configure the monitor port 

uni uni-number monitor-port 

Required  

 

z 

When a UNI is configured as the monitor port for port mirroring, it is recommended that you set the 

VLAN operation mode of the port to transparent so that it will forward packets without making any 

change. For details, refer to EPON-OLT Configuration in the Access Volume.  

z 

You are recommended to use a monitor port only for port mirroring. This is to ensure that the data 

monitoring device receives and analyzes only the mirrored traffic rather than a mix of mirrored 

traffic and normally forwarded traffic.