3com S7906E 설치 설명서

 

1-31 

# Configure an IPv6 address for VLAN-interface 101 (the physical interface of the tunnel). 

[SwitchB] interface vlan-interface 101 

[SwitchB-Vlan-interface101] ipv6 address 2002::2:1 64 

[SwitchB-Vlan-interface101] quit 

# Create the interface tunnel 2. 

[SwitchB] interface tunnel 2 

# Configure an IPv4 address for the interface tunnel 2. 

[SwitchB-Tunnel2] ip address 30.1.2.2 255.255.255.0 

# Configure the tunnel encapsulation mode. 

[SwitchB-Tunnel2] tunnel-protocol ipv4-ipv6 

# Configure the source address for the interface tunnel 2 (IP address of VLAN-interface 101). 

[SwitchB-Tunnel2] source 2002::2:1 

# Configure the destination address for the interface tunnel 2 (IP address of VLAN-interface 101 of 

Switch A). 

[SwitchB-Tunnel2] destination 2002::1:1 

[SwitchB-Tunnel2] quit 

# Create service loopback group 1 to support the tunnel service. 

[SwitchB] service-loopback group 1 type tunnel 

# Add GigabitEthernet 2/0/3 to service loopback group 1. 

[SwitchB] interface GigabitEthernet 2/0/3 

[SwitchB-GigabitEthernet2/0/3] undo stp enable 

[SwitchB-GigabitEthernet2/0/3] port service-loopback group 1 

[SwitchB-GigabitEthernet2/0/3] quit 

# Reference service loopback group 1 on the tunnel. 

[SwitchB] interface tunnel 2 

[SwitchB-Tunnel2] service-loopback-group 1 

[SwitchB-Tunnel2] quit 

# Configure a static route from Switch B through the interface tunnel 2 to Group 1. 

[SwitchB] ip route-static 30.1.1.0 255.255.255.0 tunnel 2 

After the configuration, display the status of the tunnel interfaces on Switch A and Switch B, 

respectively. 

<SwitchA> display interface tunnel 1 

Tunnel1 current state: UP 

Line protocol current state: UP 

Description: Tunnel1 Interface 

The Maximum Transmit Unit is 1460 

Internet Address is 30.1.2.1/24 Primary 

Encapsulation is TUNNEL, service-loopback-group ID is 1. 

Tunnel source 2002::1:1, destination 2002::2:1 

Tunnel protocol/transport IP/IPv6