3com S7906E 설치 설명서

 

2-5 

  This command will set the boot file of the specified board. Continue? [Y/N]:y 

  The specified file will be used as the main boot file at the next reboot on slot 1! 

# Reboot the device and the software is upgraded. 

<Sysname> reboot 

 

The startup file used for the next startup must be saved under the root directory of the storage medium. 

You can copy or move a file to the root directory of the storage medium. For the details of the 

boot-loader command, refer to Device Management Commands in the System Volume. 

 

z 

As shown in 

, Device is a IRF system, which is composed of a master and a slave. The 

member ID of the master is 1, and the slot numbers of the AMB and the SMB on the master are 0 

and 1 respectively. The member ID of the slave is 2, and the slot numbers of the AMB and SMB on 

the slave are 0 and 1 respectively. 

z 

Device serves as a TFTP client and PC as the TFTP server. Their IP addresses are as shown in 

the following figure. Device and PC are reachable to each other. 

z 

Device downloads a startup file from PC for upgrade and uploads a configuration file named 

config.cfg to PC for backup. 

Figure 2-3 Smooth upgrading using the TFTP client function 

 

 

1)  Configure PC (TFTP Server), the detailed configuration procedure is omitted. 

z 

On the PC, enable TFTP server 

z 

Configure a TFTP working directory 

2)  Configure Device (TFTP Client)