3com S7906E 설치 설명서
1-12
Currently, when you configure load-balancing link aggregation groups in system view, the switch
supports configuring hash keys in the following modes:
z
Use a source IP address, a destination IP address, a source MAC address, or a destination MAC
address alone as a hash key.
z
Combine a source IP address and a destination IP address, a source IP address and a source port
number, a destination IP address and a destination port number, or a source MAC address and
destination MAC address to form a hash key.
z
Combine any two or all three of the following elements to form a hash key: ingress port number,
source MAC address, and destination MAC address.
Configuring a load sharing mode for a link aggregation group
Follow these steps to configure a load sharing mode specific to a link aggregation group:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter aggregate interface
view
view
interface bridge-aggregation
interface-number
interface-number
—
Configure the load sharing
mode for the aggregation
group
mode for the aggregation
group
link-aggregation
load-sharing mode
{ destination-ip |
destination-mac |
mpls-label1 | mpls-label2 |
source-ip | source-mac } *
load-sharing mode
{ destination-ip |
destination-mac |
mpls-label1 | mpls-label2 |
source-ip | source-mac } *
Required
By default, the load sharing mode of
an aggregation group is the global
load sharing mode.
an aggregation group is the global
load sharing mode.
This command applies only to the
load sharing mode of Layer 3
packets. After you configure this
command, the Layer 3 load sharing
modes in current link aggregation
group change accordingly, but the
Layer 2 load sharing modes will not
be affected. The permanent
source/destination MAC addresses
will still be used as the hash keys.
load sharing mode of Layer 3
packets. After you configure this
command, the Layer 3 load sharing
modes in current link aggregation
group change accordingly, but the
Layer 2 load sharing modes will not
be affected. The permanent
source/destination MAC addresses
will still be used as the hash keys.
Currently, when you configure load-balancing link aggregation groups in Layer 2 aggregate interface
view, the switch supports configuring hash keys in the following modes:
z
Use a source IP address, a destination IP address, a source MAC address, a destination MAC
address, or a mpls-label1 alone as a hash key.
z
Combine a source IP address and a destination IP address, a source MAC address and destination
MAC address, a mpls-label1 and mpls-label2 to form a hash key.