3com S7906E 설치 설명서
1-6
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter OSPFv3 view
ospfv3 [ process-id ]
—
Enter OSPFv3 area view
area area-id
—
Configure the area as a stub
area
area
stub [ no-summary ]
Required
Not configured by default
Specify a cost for the default
route advertised to the stub
area
route advertised to the stub
area
default-cost value
Optional
Defaults to 1
z
You cannot remove an OSPFv3 area directly. Only when you remove all configurations in area
view and all interfaces attached to the area become down, can the area be removed.
z
All the routers attached to a stub area must be configured with the stub command. The keyword
no-summary is only available on the ABR of the stub area.
z
If you use the stub command with the keyword no-summary on an ABR, the ABR advertises a
default route in an Inter-Area-Prefix-LSA into the stub area. No AS-external-LSA,
Inter-Area-Prefix-LSA or Inter-Area-Router-LSA is advertised in the area. The stub area of this kind
is also known as a totally stub area.
Configuring an OSPFv3 Virtual Link
You can configure a virtual link to maintain connectivity between a non-backbone area and the
backbone, or in the backbone itself.
Follow these steps to configure a virtual link:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter OSPFv3 view
ospfv3 [ process-id ]
—
Enter OSPFv3 area view
area area-id
—
Configure a virtual link
vlink-peer router-id [ hello seconds |
retransmit seconds | trans-delay seconds |
dead seconds | instance instance-id ] *
retransmit seconds | trans-delay seconds |
dead seconds | instance instance-id ] *
Required