3com S7906E 설치 설명서
1-23
Total number of peers : 3 Peers in established state : 3
Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State
10::2 65008 3 3 0 0 00:01:16 Established
9:3::2 65009 2 3 0 0 00:00:40 Established
9:1::2 65009 2 4 0 0 00:00:19 Established
# Display IPv6 peer information on Switch C.
[SwitchC] display bgp ipv6 peer
BGP local router ID : 3.3.3.3
Local AS number : 65009
Total number of peers : 2 Peers in established state : 2
Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State
9:3::1 65009 4 4 0 0 00:02:18 Established
9:2::2 65009 4 5 0 0 00:01:52 Established
Switch A and B has established an eBGP connection; Switch B, C and D have established iBGP
connections with each other.
IPv6 BGP Route Reflector Configuration
Network requirements
As shown in the following figure, Switch B receives an eBGP update and sends it to Switch C, which is
configured as a route reflector with two clients: Switch B and Switch D.
Switch B and Switch D need not establish an iBGP connection because Switch C reflects updates
between them.
Figure 1-2 Network diagram for IPv6 BGP route reflector configuration
Vlan-int200
100::1/96
100::1/96
Switch A
AS 100
Vlan-int200
100::2/96
Vlan-int300
101::2/96
101::2/96
Vlan-int100
102::2/96
102::2/96
Vlan-int100
102::1/96
102::1/96
Vlan-int300
101::1/96
Switch C
Switch B
Switch D
IBGP
IBGP
AS 200
Route
reflector
Configuration procedure
1) Configure IPv6 addresses for VLAN interfaces (omitted)
2) Configure IPv6 BGP basic functions
# Configure Switch A.
<SwitchA> system-view