3com S7906E 설치 설명서

 

1-5 

[SwitchA-behavior-a] redirect next-hop 202.1.1.2 

[SwitchA-behavior-a] quit 

# Associate class a with behavior a in QoS policy a.  

[SwitchA] qos policy a 

[SwitchA-qospolicy-a] classifier a behavior a 

[SwitchA-qospolicy-a] quit 

# Apply QoS policy a to the incoming traffic of GigabitEthernet 2/0/1.  

[SwitchA] interface gigabitethernet 2/0/1 

[SwitchA-GigabitEthernet2/0/1] qos apply policy a inbound 

After completing the configuration, verify that when Switch A receives packets with destination IP 

address 201.1.1.2, it forwards the packets to Switch C instead of Switch B. 

As shown in 

, redirect all packets received on GigabitEthernet 2/0/1 of Switch A to the next 

hop 202::2. 

Figure 1-2 Network diagram for IPv6 policy routing configuration 

 

 

# Configure IPv6 ACL 2000. 

<SwitchA> system-view 

[SwitchA] acl ipv6 number 2000 

[SwitchA-acl6-basic-2000] rule 0 permit source any 

[SwitchA-acl6-basic-2000] quit 

# Define a match criterion for class a to match IPv6 ACL 2000. 

[SwitchA] traffic classifier a 

[SwitchA-classifier-a] if-match acl ipv6 2000 

[SwitchA-classifier-a] quit 

# Configure the action of redirecting traffic to the next hop 202::2 for behavior a. 

[SwitchA] traffic behavior a 

[SwitchA-behavior-a] redirect next-hop 202::2