3com S7906E 참조 가이드

 

1-17 

interface-type interface-number : Interface type and interface number.  

Use the interface command to enter interface. 

# Enter Ethernet 2/0/1 interface view (assuming that the interface is a Layer 2 Ethernet interface). 

<Sysname> system-view 

[Sysname] interface ethernet 2/0/1 

[Sysname-Ethernet2/0/1] 

jumboframe enable [ value ] 

undo jumboframe enable 

Layer 2 Ethernet interface view, port group view 

2: System level 

value: Maximum length of Ethernet frames that are allowed to pass through. The effective range is 

1,536 to 9,216 (in bytes). 

Use the jumboframe enable command to allow jumbo frames with the specified length to pass through 

an Ethernet interface. 

Use the undo jumboframe enable command to prevent jumbo frames from passing through an 

Ethernet interface. That is, the maximum length of the frames allowed to pass through an Ethernet 

interface is 1518 bytes.  

By default, the device allows frames no larger than 1536 bytes to pass through an Ethernet interface. 

You can configure length of jumbo frames in global configuration mode (in system view) or on a port (in 

Ethernet interface view, port-group view) to allow them to pass through Ethernet interfaces. 

z 

Execution of this command under Ethernet interface view will only apply the configurations to the 

current Ethernet interface. 

z 

Execution of this command under port group view will apply the configurations to the Ethernet 

interface(s) in the port group.