3com S7906E 참조 가이드

 

1-25 

z 

If you set different suppression ratios in Ethernet interface view or port-group view for multiple 

times, the latest configuration takes effect. 

z 

Do not use the multicast-suppression command along with the storm-constrain command. 

Otherwise, the multicast storm suppression ratio configured may get invalid. 

z 

On an Ethernet port enabled with multicast storm suppression ratio, this feature takes effect only in 

the inbound direction.  

 

# For Ethernet interface Ethernet 2/0/1, allow multicast traffic equivalent to 20% of the total transmission 

capability of Ethernet 2/0/1 to pass. 

<Sysname> system-view 

[Sysname] interface ethernet 2/0/1 

[Sysname-GigabitEthernet2/0/1] multicast-suppression 20 

# For all the ports of the manual port group group1, allow multicast traffic equivalent to 20% of the total 

transmission capability of each port to pass. 

<Sysname> system-view 

[Sysname] port-group manual group1 

[Sysname-port-group-manual-group1] group-member ethernet 2/0/1 

[Sysname-port-group-manual-group1] group-member ethernet 2/0/2 

[Sysname-port-group-manual-group1] multicast-suppression 20 

port-group manual port-group-name 

undo port-group manual port-group-name 

System view 

2: System level 

port-group-name: Specifies name of a manual port group, a string of 1 to 32 characters. 

Use the port-group manual command to create a manual port group and enter manual port group 

view. 

Use the undo port-group manual command to remove a manual port group. 

By default, no manual port group is created.