3com S7906E 참조 가이드

 

1-30 

undo ip ipv6-prefix ipv6-prefix-name [ index index-number ] 

System view 

2: System level 

ipv6-prefix-name: IPv6 prefix list name, a string of 1 to 19 characters, for uniquely specifying an IPv6 

prefix list.  

index-number: Index number, in the range 1 to 65535, for uniquely specifying an IPv6 prefix list item. An 

item with a smaller index-number will be matched first.  

permit: Specifies the matching mode for the IPv6 prefix list item as permit, that is, if a route matches the 

item, it passes the IPv6 prefix list without needing to match against the next item; if not, it will match 

against the next item (suppose the IPv6 prefix list has multiple items configured). 

deny: Specifies the matching mode for the IPv6 prefix list item as deny, that is, if a route  matches the 

item, the route neither passes the filter nor matches against the next item; if not, the route will match 

against the next item (suppose the IPv6 prefix list has multiple items configured). 

ipv6-address prefix-length: Specifies an IPv6 prefix and prefix length. A prefix-length is in the range 0 to 

128. When specified as :: 0, the arguments matche the default route. 

greater-equal min-prefix-length: Greater than or equal to the minimum prefix length.  

less-equal max-prefix-length: Less than or equal to the maximum prefix length. 

The length relation is mask-length <= min-mask-length <= max-mask-length <= 128. If only the 

min-prefix-length is specified, the prefix length range is [ min-prefix-length, 128 ]. If only the 

max-prefix-length is specified, the prefix length range is [ prefix-length, max-prefix-length ]. If both the 

min-prefix-length and max-prefix-length are specified, the prefix length range is [ min-prefix-length, 

max-prefix-length ].  

Use the ip ipv6-prefix command to configure an IPv6 prefix list or an item of it.  

Use the undo ip ipv6-prefix command to remove an IPv6 prefix list or an item.  

No IPv6 prefix list is configured by default.  

An IPv6 prefix list may have multiple items, and each of them specifies a range of IPv6 prefixes. The 

relation between items is logic OR, namely, if a route passes an item of it, the route will pass the IPv6 

prefix list.  

The IPv6 prefix range is determined by prefix-length and [ min-prefix-length, max-prefix-length ]. If both 

mask-length and [ min-mask-length, max-mask-length ] are specified, then the IPv6 addresses must 

satisfy both of them.  

If ipv6-address prefix-length is specified as :: 0, only the default route matches.  

To match all routes, configure :: 0 less-equal 128.  

# Permit IPv6 addresses with a mask length between 32 bits and 64 bits.