3com S7906E 참조 가이드

 

1-3 

Related commands: multicast routing-table in the Multicast Routing and Forwarding Commands in 

the IP Multicast Volume; igmp-snooping enable in the IGMP Snooping Commands in the IP Multicast 

Volume.  

# Enable IGMP Snooping in VLAN 100. Configure it as a multicast VLAN and enter multicast VLAN 

view.  

<Sysname> system-view 

[Sysname] igmp-snooping 

[Sysname-igmp-snooping] quit 

[Sysname] vlan 100 

[Sysname-vlan100] igmp-snooping enable 

[Sysname-vlan100] quit 

[Sysname] multicast-vlan 100 

[Sysname-mvlan-100] 

port interface-list 

undo port { all | interface-list } 

Multicast VLAN view 

2: System level 

interface-list: Specifies a port in the form of interface-type interface-number, or a port range in the form 

of  interface-type start-interface-number  to  interface-type  end-interface-number, where the end 

interface number must be greater than the start interface number.  

all: Deletes all the ports in the current multicast VLAN.  

Use the port command to assign the specified port(s) to the current multicast VLAN.  

Use the undo port command to delete the specified port(s) or all ports from the current multicast VLAN.  

By default, a multicast VLAN has no ports.  

Note that: 

z 

A port can belong to only one multicast VLAN.  

z 

Only the following types of interfaces can be configured as multicast VLAN ports: Ethernet, or 

Layer 2 aggregate interfaces.  

# Assign ports Ethernet 2/0/1 through Ethernet 2/0/5 to multicast VLAN 100.  

<Sysname> system-view