3com S7906E 참조 가이드
1-3
<Sysname> display mpls interface vlan-interface 2 verbose
No : 1
Interface : Vlan2
Status : Down
TE Attribute : Disable
LSPCount : 0
CR-LSPCount : 0
FRR : Disabled
Table 1-2 display mpls interface command output description
Field
Description
TE Attr/TE Attribute
Whether TE is enabled on the interface
LSPCount
Number of LSPs on the interface
CR-LSPCount
Number of CR-LSPs on the interface
FRR
Whether FRR is enabled on the interface. If FRR is enabled,
the output will also include the bound tunnels.
the output will also include the bound tunnels.
display mpls label
Syntax
display mpls label { label-value1 [ to label-value2 ] | all }
View
Any view
Default Level
1: Monitor level
Parameters
label-value1: Specifies a label or, when used with the label-value2 argument, the start label of a range of
labels. The value of this argument ranges from 16 to 8191.
to label-value2: Specifies the end label of a range of labels, in the range 16 to 8191.
all: Specifies all labels.
Description
Use the display mpls label command to display information about specified labels or all labels.
Examples
# Display information about labels in the range 900 to 1500.
<Sysname> display mpls label 900 to 1500
Label alloc state: '.' means not used, '$' means used
------------------------------Static Label--------------------------------
900:........ ........ ........ ........ ........ ........ ........ ........
964:........ ........ ........ ........ ........ ........ ........ ....
------------------------------Dynamic Label-------------------------------