3com S7906E 참조 가이드

 

3-7 

0s address, all 1s address, a class D address, a class E address or a loopback address. 

Use the nas-ip command to set the IP address for the device to use as the source address of the 

HWTACACS packets to be sent to the server.  

Use the undo nas-ip command to remove the configuration. 

By default, the source IP address of a packet sent to the server is the IP address of the outbound port. 

Note that: 

z 

Specifying a source address for the HWTACACS packets to be sent to the server can avoid the 

situation where the packets sent back by the HWTACACS server cannot reach the device as the 

result of a physical interface failure. 

z 

If you configure the command for more than one time, the last configuration takes effect.  

z 

The nas-ip command in HWTACACS scheme view is only for the current HWTACACS scheme, 

while the hwtacacs nas-ip command in system view is for all HWTACACS schemes. However, the 

nas-ip command in HWTACACS scheme view overwrites the configuration of the hwtacacs 

nas-ip command. 

Related commands: hwtacacs nas-ip. 

# Set the IP address for the device to use as the source address of the HWTACACS packets to 10.1.1.1. 

<Sysname> system-view 

[Sysname] hwtacacs scheme hwt1 

[Sysname-hwtacacs-hwt1] nas-ip 10.1.1.1 

primary accounting ip-address [ port-number ] 

HWTACACS scheme view 

2: System level 

ip-address: IP address of the server, a valid unicast address in dotted decimal notation. The default is 

0.0.0.0. 

port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49. 

Use the primary accounting command to specify the primary HWTACACS accounting server.  

Use the undo primary accounting command to remove the configuration. 

By default, no primary HWTACACS accounting server is specified.