3com S7906E 참조 가이드

 

1-3 

Table 1-2 display user-bind command output description 

Total entries found 

Total number of found entries 

MAC 

MAC address of the binding. N/A means that no MAC address is bound in 
the entry. 

IP 

IP address of the binding. N/A means that no IP address is bound in the 
entry. 

Vlan 

Static binding entry does not support VLAN-port binding. N/A means that 
no VLAN is bound in the entry. 

Port 

Port of the binding 

Status 

Type of the binding. Static means that the binding is manually configured. 

 

ip check source { ip-address | ip-address mac-address | mac-address } 

undo ip check source 

Ethernet interface view, VLAN interface view 

2: System level 

ip-address: Specifies to bind source IP address to the port. 

ip-address mac-address: Specifies to bind source IP address and MAC address to the port. 

mac-address: Specifies to bind source MAC address to the port. 

Use the ip check source command to configure the dynamic binding function on a port. 

Use the undo ip check source command to restore the default.  

By default, the dynamic binding function is disabled.  

Note that: You cannot configure the dynamic binding function on a port that is in an aggregation group. 

# Configure dynamic binding function on port Ethernet 2/0/1 to filter packets based on both source IP 

address and MAC address. 

<Sysname> system-view 

[Sysname] interface ethernet 2/0/1 

[Sysname-Ethernet2/0/1] ip check source ip-address mac-address