3com S7906E 참조 가이드
1-29
Use the undo shutdown-interval command to restore the default.
By default, the detection interval is 30 seconds.
Note that:
z
If a protocol module such as the operation, administration and maintenance (OAM) module detects
an exception on a port (for example, signal loss of the link on the peer end), the port will be closed
automatically, without execution of the shutdown command. You can set the automatic recovery
time of the port by using the shutdown-interval command.
z
The shutdown-interval command helps you to dynamically set a detection interval to cooperate
with the OAM module.
z
If you change the detection interval to T1 during interface detection, the interval from when you
change the interval to the time when detection starts is T. If T<T1, the interface which is down will
be brought up after T1-T time; if T>=T1, the interface which is down will be brought up immediately.
Examples
# Set the detection interval to 100 seconds.
<Sysname> system-view
[Sysname] shutdown-interval 100
strict-standby enable
Syntax
strict-standby enable
undo strict-standby enable
View
System view
Default Level
2: System level
Parameters
None
Description
Use the strict-standby enable command to enable active/standby mode for service ports on SRPUs.
Use the undo strict-standby enable command to disable active/standby mode for service ports on
SRPUs.