3com S7906E 참조 가이드

 

3-6 

disable: Disables ARP packet rate limit. 

pps: ARP packet rate in pps, in the range 50 to 500. 

drop: Discards the exceeded packets. 

Use the arp rate-limit command to configure or disable ARP packet rate limit. If a rate is specified, 

exceeded packets are discarded. 

Use the undo arp rate-limit command to restore the default. 

By default, ARP packet rate limit is enabled, and the ARP packet rate is 100 pps. 

# Specify the ARP packet rate on GigabitEthernet 2/0/1 as 30 pps, and exceeded packets are 

discarded. 

<Sysname> system-view 

[Sysname] interface gigabitethernet 2/0/1 

[Sysname-GigabitEthernet2/0/1] arp rate-limit rate 30 drop 

Any view 

1: Monitor level 

None 

Use the display arp detection command to display the VLAN(s) enabled with ARP detection. 

Related commands: arp detection enable. 

# Display the VLANs enabled with ARP detection. 

<Sysname> display arp detection 

ARP detection is enabled in the following VLANs: 

1, 2, 4-5