3com S7906E 참조 가이드
1-10
This command is intended for the follow-up display of routing policies. If the specified prefix list is not
configured, detailed information about all routes (with the verbose keyword) or brief information about
all active routes (without the verbose keyword) is displayed.
Examples
# Configure a prefix list named test, permitting routes with a prefix of 2.2.2.0 and a mask length
between 24 and 32.
<Sysname> system-view
[Sysname] ip ip-prefix test permit 2.2.2.0 24 less-equal 32
# Display brief information about active routes permitted by the prefix list test.
[Sysname] display ip routing-table ip-prefix test
Routes Matched by Prefix list : test
Summary Count : 2
Destination/Mask Proto Pre Cost NextHop Interface
2.2.2.0/24 Direct 0 0 2.2.2.1 Vlan2
2.2.2.1/32 Direct 0 0 127.0.0.1 InLoop0
For detailed description of the above output, see
.
# Display detailed information about both active and inactive routes permitted by IP prefix list test.
[Sysname] display ip routing-table ip-prefix test verbose
Routes Matched by Prefix list test :
Summary Count : 2
Destination: 2.2.2.0/24
Protocol: Direct Process ID: 0
Preference: 0 Cost: 0
NextHop: 2.2.2.1 Interface: Vlan2
RelyNextHop: 0.0.0.0 Neighbour: 0.0.0.0
Tunnel ID: 0x0 Label: NULL
State: Active Adv Age: 00h20m52s
Tag: 0
Destination: 2.2.2.1/32
Protocol: Direct Process ID: 0
Preference: 0 Cost: 0
NextHop: 127.0.0.1 Interface: InLoop0
RelyNextHop: 0.0.0.0 Neighbour: 0.0.0.0
Tunnel ID: 0x0 Label: NULL
State: Active NoAdv Age: 00h20m52s
Tag: 0
For detailed description of the above output, see
.
display ip routing-table protocol
Syntax
display ip routing-table protocol protocol [ inactive | verbose ]