3com S7906E 참조 가이드

 

1-21 

[Sysname] route-policy abc permit node 0 

[Sysname-route-policy] if-match ip-prefix 123 

[Sysname-route-policy] apply cost 6 

[Sysname] interface vlan-interface 10 

[Sysname-Vlan-interface10] rip metricin route-policy abc 2 

rip metricout [ route-policy route-policy-name ] value 

undo rip metricout 

Interface view 

value: Additional metric of sent routes, in the range of 1 to 16. 

Use the rip metricout command to add a metric to sent routes. 

Use the undo rip metricout command to restore the default. 

By default, the additional metric for sent routes is 1. 

With the command configured on an interface, the metric of RIP routes sent on the interface will be 

increased. 

If a routing policy is referenced with the route-policy keyword: 

z 

Routes matching the policy is added with the metric specified in the apply cost command 

configured in the policy, while routes not matching it is added with the metric specified in the rip 

metricout command. Note that, the rip metricout command does not support the + or – keyword 

(used to add or reduce a metric) specified in the apply cost command. For details about the apply 

cost command, refer to Routing Policy Commands in the IP Routing Volume. 

z 

If the apply cost command is not configured in the policy, all the advertised routes is added with 

the metric specified in the rip metricout command. 

Related commands: rip metricin. 

#  Configure VLAN-interface 10 to add a metric of 6 for the outgoing route 1.0.0.0/8 and to add a metric 

of 2 for other outgoing routes. 

<Sysname> system-view 

[Sysname] ip ip-prefix 123 permit 1.0.0.0 8 

[Sysname] route-policy abc permit node 0 

[Sysname-route-policy] if-match ip-prefix 123 

[Sysname-route-policy] apply cost 6 

[Sysname] interface vlan-interface 10 

[Sysname-Vlan-interface10] rip metricout route-policy abc 2