3com S7906E 참조 가이드

 

1-65 

BGP view 

2: System level 

None  

Use the reflect between-clients command to enable route reflection between clients.  

Use the undo reflect between-clients command to disable this function. 

By default, route reflection between clients is enabled. 

After a route reflector is configured, it reflects the routes of a client to other clients. If the clients of a 

route reflector are fully meshed, you need disable route reflection between clients to reduce routing 

costs.  

Related commands: reflector cluster-id and peer reflect-client. 

# Disable route reflection between clients. 

<Sysname> system-view 

[Sysname] bgp 100 

[Sysname-bgp] undo reflect between-clients 

reflector cluster-id { cluster-id | ip-address } 

undo reflector cluster-id 

BGP view  

2: System level 

cluster-id: Cluster ID in the format of an integer from 1 to 4294967295. 

ip-address: Cluster ID in the format of an IPv4 address in dotted decimal notation. 

Use the reflector cluster-id command to configure the cluster ID of the route reflector.  

Use the undo reflector cluster-id command to remove the configured cluster ID. 

By default, each route reflector uses its router ID as the cluster ID.