3com S7906E 참조 가이드
1-10
Field
Description
late collisions
Number of times frames were delayed due to the detection of
collisions after the first 512 bits of the frames were already on
the network
collisions after the first 512 bits of the frames were already on
the network
lost carrier
Number of times the carrier was lost during transmission. This
counter applies to serial WAN interfaces.
counter applies to serial WAN interfaces.
- no carrier
Number of times the carrier was not present in the
transmission. This counter applies to serial WAN interfaces.
transmission. This counter applies to serial WAN interfaces.
“-“ indicates that the corresponding entry is not supported.
display loopback-detection
Syntax
display loopback-detection
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display loopback-detection command to display loopback detection information on a port.
If loopback detection is already enabled, this command will also display the detection interval and
information on the ports currently detected with a loopback.
Examples
# Display loopback detection information on a port.
<Sysname> display loopback-detection
Loopback-detection is running
Detection interval time is 30 seconds
No port is detected with loopback
Table 1-3 display loopback-detection command output description
Field
Description
Loopback-detection is running
Loopback-detection is running.
Detection interval time is 30 seconds
Detection interval is 30 seconds.