3com S7906E 참조 가이드

 

1-30 

Use the undo ospfv3 dr-priority command to restore the default value.  

The DR priority on an interface defaults to 1. 

An interface’s DR priority determines its privilege in DR/BDR selection, and the interface with the 

highest priority is preferred.  

# Set the DR priority for an interface in instance 1 to 8.  

<Sysname> system-view 

[Sysname] interface vlan-interface 10 

[Sysname-Vlan-interface10] ospfv3 dr-priority 8 instance 1 

ospfv3 mtu-ignore [ instance instance-id ] 

undo ospfv3 mtu-ignore [ instance instance-id ] 

Interface view 

2: System level 

instance-id: Instance ID, in the range 0 to 255, which defaults to 0.  

Use the ospfv3 mtu-ignore command to configure an interface to ignore MTU check during DD packet 

exchange. 

Use the undo ospfv3 mtu-ignore command to restore the default.  

By default, an interface performs MTU check during DD packet exchange. A neighbor relationship can 

be established only if the interface’s MTU is the same as that of the peer.  

# Configure an interface that belongs to instance 1 to ignore MTU check during DD packet exchange.  

<Sysname> system-view 

[Sysname] interface vlan-interface 10 

[Sysname-Vlan-interface10] ospfv3 mtu-ignore instance 1 

ospfv3 network-type { broadcast | nbma | p2mp [ non-broadcast ] | p2p } [ instance instance-id ] 

undo ospfv3 network-type [ instance instance-id ]