3com MSR 20-20 참조 매뉴얼

group-name: Name of a peer group, a string of 1 to 47 characters.

ip-address: IP address of a peer.

route-policy-name: Routing policy name, a string of 1 to 19 characters.

export: Applies the routing policy to routes outgoing to the peer (or peer group).

import: Applies the routing policy to routes incoming from the peer (or peer 
group).

Use the peer route-policy command to apply a routing policy to routes 
incoming from or outgoing to a peer or peer group.

Use the undo peer route-policy command to remove the configuration.

By default, no inbound/outbound routing policy is configured for the peer/peer 
group.

The peer route-policy command does not apply the if-match interface clause in 
the referenced routing policy. Refer to “route-policy” on page 1205 and “if-match 
interface” on page 1200

# In BGP view, apply routing policy test-policy to routes outgoing to peer group 
test.

<Sysname> system-view

[Sysname] bgp 100

[Sysname-bgp] peer test route-policy test-policy export 

# In BGP-VPN instance view, apply routing policy test-policy to routes outgoing to 
the peer group test (the VPN has been created).

<Sysname> system-view

[Sysname] bgp 100

[Sysname-bgp] ipv4-family vpn-instance vpn1

[Sysname-bgp-vpn1] peer test route-policy test-policy export 

peer { group-name | ip-address } route-update-interval seconds

undo peer { group-name | ip-address } route-update-interval

BGP view/BGP-VPN instance view

group-name: Name of a peer group, a sting of 1 to 47 characters.

ip-address: IP address of a peer.

seconds: Minimum interval for sending the same update message. The range is 5 
to 600 seconds.