3com MSR 20-20 참조 매뉴얼

C

HAPTER

 74: IS-IS C

ONFIGURATION

 C

OMMANDS

IS-IS view

None

Use the log-peer-change command to enable logging on IS-IS adjacency state 
changes.

Use the undo log-peer-change command to disable the logging.

The feature is enabled by default.

After the feature is enabled, information about IS-IS adjacency state changes is 
sent to the configuration terminal.

# Enable logging on the IS-IS adjacency state changes.

<Sysname> system-view

[Sysname] isis

[Sysname-isis-1] log-peer-change 

lsp-fragments-extend  [ [ level-1 | level-2 | level-1-2 ] | [ mode-1 | mode-2 ] ]  *

IS-IS view

mode-1: Fragment extension mode 1, used on a network where some routers do 
not support LSP fragment extension.

mode-2: Fragment extension mode 2, used on a network where all routers 
support LSP fragment extension.

level-1: Applies the fragment extension mode to Level-1 LSPs.

level-2: Applies the fragment extension mode to Level-2 LSPs.

level-1-2: Applies the fragment extension mode to both Level-1 and Level-2 LSPs.

n