3com MSR 20-20 참조 매뉴얼
1
P
UBLIC
ATM
AND
DSL I
NTERFACE
C
OMMANDS
display interface atm
Syntax
display interface atm [ interface-number ]
View
Any view
Parameter
interface-number: Interface number. If no interface is specified, the configuration
and status information about all ATM/DSL interfaces and channels on them is
displayed.
and status information about all ATM/DSL interfaces and channels on them is
displayed.
Description
Use the display interface atm command to display the configuration and status
information about an ATM interface or a DSL interface.
information about an ATM interface or a DSL interface.
If no interface is specified, this command displays the configuration and status
information about all ATM interfaces and DSL interfaces.
information about all ATM interfaces and DSL interfaces.
Example
# Display the configuration and state information about interface ATM 2/0.
<Sysname> display interface atm 2/0
Atm2/0 current state :DOWN
Line protocol current state :DOWN
Description :
Atm2/0 Interface
The Maximum Transmit Unit is 1500
Internet protocol processing : disabled
AAL enabled: AAL5, Maximum VCs: 128
Current VCs: 0 (0 on main interface)
ATM over E1, Scramble enabled, frame-format crc4-adm
code hdb3, clock slave,Cable-length long, loopback not set
Cable type:
75 ohm non-balanced
Line Alarm: LOS LOF
Line Error: 0 FERR, 0 LCV, 0 CERR, 0 FEBE
Last 0 seconds input
rate 0.00 bytes/sec, 0.00 packets/sec
Last 0 seconds output rate 0.00 bytes/sec, 0.00 packets/sec
Input : 0 packets, 0 bytes, 0 buffers
0 errors, 0 crcs, 0 lens, 0 giants,
0 pads, 0 aborts, 0 timeouts
0 overflows, 0 overruns,0 no buffer
Output: 0 packets, 0 bytes, 0 buffers
0 errors, 0 overflows, 0 underruns